The printer's power must be turned OFF before making any DIP switch changes.

If you have been printing, allow the print head to cool down before touching it.

To set the DIP switches:
1. Open the printer cover.
2. Remove the ribbon cassette.
3. Manually push the print head to the right side of the printer.
4. Grasp the fin of the compartment cover on the mechanical frame. Slide it to the left, and remove it.

After setting the DIP switches, replace the compartment cover, re-install the ribbon cassette and replace the printer cover.

The DIP switch settings are read only after the initialization process when the printer's power is turned ON.

DIP Switch Bank 1

Note 1: Standard and IBM modes are selected only by using DIP switch 1-4. There is no control code to designate Standard or IBM mode.

Note 2:
DC1 Code ........ Select printer through software
DC3 Code ........ Deselect printer through software.

Note 1: These character selections are valid for Standard Character Set, IBM Character Set 1, and IBM Character Set 2.

Note 2: When DENMARK is selected in the Standard Character Set and in the IBM Character Set 1, the above DENMARK characters are available. However, when DENMARK is selected in the IBM Character Set 2, the U.S.A. character becomes available, and the code (9B)Hex or (155)Decimal cooresponds to the print-out of a small slashed zero and the code (9D)Hex or (157)Decimal, to the print-out of a large slashed zero.

DIP Switch Bank 2

a. Serial transfer rates

b. Serial protocol selection

c. Parity selection

d. Serial data length